Internet Search Results 

Tips on if Your pellet stove is burning lazy and or getting smoke in ...
The last time I was at that house MY SELF for a full service about 3 years ago it had a wood stove cap on it. We took it off and put on a wood stove cap and ran the stove. Worked good. 4 hours latter she calls doing it again. I tell her to leave the stove on. I go out there put a Magnahilic gage on it. Poor pressure and little change with air ...

heating entire house from basement | Hearth.com Forums Home
we are looking at buying a house that has a stone fireplace in the living room and a place in the basement to connect a woodstove, the house is 1456 sq ft on one floor and the basement is same sq. footage and completely open. was wondering if placing a woodstove in the basement wood supply enough heat to the main living floor to heat without ...

No power to circulator pump | Hearth.com Forums Home
So if you tie the burner & pump together, the pump will stop every time the boiler gets up to temp. If the 8148 aquatstat is faulty, I would replace it. $130 on Supply House website. But I would first make very sure it is faulty. Part of a typical setup also is that there is a zone valve between the thermostat, and the aquatstat.

Vermont casting dauntless | Hearth.com Forums Home
I just bought this stove, without a cat,this year as I moved into a new house, and replaced the old stove onto the existing chimney system. It is a wall exit setup with 2 90s and is probably a hair too short to meet normal standards. However, when the stove is running well, draft is not an issue.

Clothes dryer heat recovery heat exchanger - Hearth.com Forums
This is a double win in that you get the free heat from both the hot air and heat of vaporization of the water, and you also keep the dryer from pulling cold outside air into the house that needs to be heated by your furnace. You can check my numbers, but I get that a system like this could cut total clothes drying energy (electric and HVAC) by ...

House layout | Hearth.com Forums Home
House size is about 1225 sq.ft., and not well insulated (MAYBE r-11 in the attic), and I lose heat somewhat quickly. I'll be working on the insulation. The stove we have now is about 2.4 cu. ft., and does a good job keeping the house warm, so I'm thinking a similar sized stove would fit the bill.

Q&A Top Loading Wood Stove - Hearth.com Forums
Question: I have just bought a house in which one of the two wood stoves is a top loading type. I am hoping you could give me some tips about proper loading and starting techniques. Is there anything unique in the operation of a top loader that I should be aware of? Thanks for your help ...

Woodstove Bans in Ontario in 2025? | Hearth.com Forums Home
I am building a new house in ON, Canada in May'24 and want to install a new wood stove. However the reseller mentioned something about woodstove bans in 2025. Anyone know? Apparently Regency is pulling their woodstove products? Thx.

Best Wood Stove? | Hearth.com Forums Home
While your intended square footage may be 1,300, your cubic footage is equivalent to that of a 2,000 square foot house or even more depending on the heights of the ceilings. Stove manufacturers’ square footage ratings are calculated assuming eight foot ceilings and a cool winter climate like the Pacific Northwest, not an extremely cold climate.

Firewood wall pass-through (air lock) | Hearth.com Forums Home
Jotul Oslo 500, Rika Integra II, Brave splitter, Nissan Leaf, Solar PV, Ground-source heat pump, fixer-upper house with a few acres and garden; dogs; cat, sons, and a very tolerant wife. “If there are no dogs in Heaven, then when I die I want to go where they went.”